보배드림

결국 미국 크루즈에도 똑같은 트렁크 어항 자체생성 문제가 있는걸로 밝혀졌는데

미국은 발빠르게 해결방안이 공지됐군요..

각 서비스센터에 하달된 내용이랍니다.

한국에서는 손재주 좋으신 분들 직접하셔도 될만큼 간단한 작업이네요.

이게 과연 3년걸려도 해결못할 껀수였는지????

Subject:10376 - Service Update for Inventory and Customer Vehicles - Water Leak at Right Tail Lamp - Expires November 30, 2011

Models: 2011 Cruze

This service update includes vehicles in dealer inventory and customer vehicles that return to the dealership for any reason and will expire November 30, 2011.
Purpose

This bulletin provides a service procedure to apply a sealer on the right tail lamp weld on certain 2011 Chevrolet Cruze vehicles. These vehicles may have been produced with sealant that was misapplied along the sheet metal seam behind the right rear tail lamp. If the sealant was misapplied, water could enter the vehicle and pool in the trunk.
This service procedure should be completed as soon as possible on involved vehicles currently in dealer inventory and customer vehicles that return to the dealer for any type of service through November 30, 2011.
Vehicles Involved

A list of involved vehicles currently in dealer inventory is available on the "Service Update Bulletin Information" link under the "Service" tab in GM GlobalConnect (US) or attached to the GlobalConnect message (Canada) used to release this bulletin. Customer vehicles that return for service, for any reason, and are still covered under the vehicle's base warranty, and are within the VIN breakpoints provided below, should be checked for vehicle eligibility.
Year - diuision - Model - From - Through
2011 - Chevrolet - Cruze - B7108121 - B7126975

Important: Dealers are to confirm vehicle eligibility prior to beginning repairs by using the Required Field actoins section in the Global Warranty system. Not all vehicles within the above breakpoints may be involved.
Parts Information

Parts required to complete this service update are to be obtained from Kent Automotive. Contact Kent Automotive at 1-888-937-5368 or Kent Automotive. Do not order this from General Motors Customer Care and Aftersales (GMCC&A).
Part Number Description - Qty/ Vehicle
P10200 (Obtain from Kent Automotive)Kent Automotive High-Tech Clear Sealer (GM P/N 9984532) (will service 2 vehicles) As Req'd

Service Procedure

 Remove the right (passenger side) tail lamp. Refer to Tail Lamp Replacement in SI.

Note: The "A" portion of the illustration shows a good sealer bead. There are no gaps or separation in the sealer bead over the metal seam. The "B" portion of the illustration shows a gap or separation in the sealer bead (1) over the metal seam.
<LI type=1>Locate any area on the right (passenger side) tail lamp metal seam where the sealer (1) is not covering or sealing the seam. Refer to illustration.

Note: Carefully review and follow the application instructions provided with the Kent Automotive Clear Sealer, P/N 9984532.
Apply Kent Automotive Clear Sealer, P/N 9984532, to fully seal exposed seam missed by the original sealer bead.

1. Install the right (passenger side) tail lamp. Refer to Tail Lamp Replacement in SI. 

자 이제는 조수석 셀프클리닝을 해결해봅시다...